$ 6.00 · 4.8 (130) · In stock
Ice fishing mount for the Garmin Livescope transducer. The 0 degree transducer mount is for the LV32, not sure if it fits the LV34. Use 3/4 pvc from home improvement store to complete. If you dont like the writing on the pvc, nail polish remover (acetone) takes it right off. We dont usually get more than 8 inches of ice so I just cut pvc to 20 inches and super glued handle on top, slide pvc thru tripod base and than glued transducer mount to bottom of pvc and than you can adjust it up and down and rotate and tighten screws to lock it in place. I used {5} 1 .5 long quarter inch bolts and nuts to attach legs to base, transducer mount to the pole mount and 1 to attach the handle to the top handle cap. (1) 1 .75 or 2 inch long quarter inch bolt and nut for the adjustment screw on the tripod base. (1) 3/4 long quarter inch socket head bolt and nut for the adjusting screw for the tripod base cap that adjust up and down movement of the pvc. For the knob that tightens transducer to the mount I used a 1 and 3/4 6M bolt and nut and a stainless washer and a rubber washer.
Garmin Livescope 3D Printing
STL file Garmin Livescope Ice Mount Tripod đ§ă»3D print design to downloadă»Cults
garmin livescope 3D Models to Print - yeggi
â· livescope perspective mount 3d models ă STLFinder ă
livescope 3D Models to Print - yeggi
Garmin best STL files for 3D printeră»346 models to downloadă»Cults
Garmin best STL files for 3D printeră»354 models to downloadă»Cults
Livescope best STL files for 3D printingă»28 models to downloadă»Cults
STL file Garmin Livescope Ice Mount Tripod đ§ă»3D print design to